0 Items

Bisley Quality QD Stud – Bipod Stud Long and Short Studs

£2.99

Bisley quality quick detach QD stud or bipod stud for mounting bipod and slings to your air gun, rifle or shotgun. A long and short wood screw threads for rifle front and rear or butt of the stock.

Genuine Bisley QD Studs.

Clear
SKU: BQQSBSLaSS Categories: , Brand:

Description

Quality quick detach Bisley QD stud or bipod stud for mounting bipod and slings to your air gun, rifle or shotgun. A long and short qd stud wood screw with threads for rifle front and rear or butt of the stock.

Genuine Bisley QD Studs.

QD stud or bipod stud features

The two qd studs come in different lengths a short stud that is 13 mm or ½ inch long threads and a long stud 18 mm or ¾ inch long threads. A pilot hole will be needed to prevent the wood from splitting.

First and foremost you should always fit a quality QD stud or bipod stud as you don’t want you air gun, rifle or shotgun hitting the ground. We recommend the Bisley QD Stud or bipod stud.
  1. Remove the stock from the action.
  2. Measure the thead with and core width of the qd stund. Select a drill bit that is just bigger than the core, but smaller than the qd studs diameter
  3. Secure your stock in a vice that has been padded so that there will not be any vice marks left on your stock.
  4. Place some marking tap where you intend to drill the hole.
  5. Mark about 5 cm from the front end of the stock and mark a centre cross. Make sure at this stage that if you were to dill at the marked point that it will not interfere with anything.
  6. Mark somewhere between 7.5 cm and 10 cm at the rear of the stock and mark a centre cross.
  7. When you are happy that you have centre crosses tap an engineers hole punch on the centre crosses. This will help stop the drill from moving round and damaging the stock.
  8. Use the shortest qd stud at the frond of the stock and the longest qd stud at the rear.
  9. Measure the length of the short stud and place a piece of masking tape on the drill bit so you know how far to drill. Repeat for the long stud when you are ready.
  10. Place the drill with the bit on the stock at a 90 degrees (vertically not diagonally). We recommend you use a pillar drill as this will ensure your drill is 90 degrees in both axis’s.
  11. Drill a bit at a time until you reach your mark.
  12. The place the QD stud with the washer and screw down into place. The stud should not totally swash the washer and the hole of the stud should 90 degrees to the stock.
  13. Repeat step 9 to 12 for the rear of the stock.

QD stud or Bipod Stud waring notice

Please double check after installing your new fittings to your gun, that they will support its weight air gun, rifle or shotgun. It is best to test this out in a safe location, where it wont damage your gun if there is any issue.

Additional information

Size

,

Reviews

There are no reviews yet.

Be the first to review “Bisley Quality QD Stud – Bipod Stud Long and Short Studs”

Your email address will not be published. Required fields are marked *